How to download WINCE image on Wecon hmi

To do all these update will make the display of Chinese font available.

You can do it according the following steps:

1. Set your PC hyper terminal as 115200， 8bits， 1bit for stop， none parity.

2. Connect serial cable between PC serial port and HMI port 2:

The pins connected are as:

HMI PC

2--------3

3--------2

5--------5

3. Keep pressing space key in your PC’s hyper terminal while you power on your HMI：

4. If ok， the Hyper terminal will display like following. If not， power on HMI again， and repeat step 3.

5. Select “7” to format the nand flash. Wait until it finish.

6. Select “8” to use USB to download image. Use WECON USB cable to connect PC and HMI. Then the notice will be displayed in your PC for installing USB driver. The driver is in the same folder.

7. When the driver is installed， run the file “dnw.exe”. Use the menu “USB port” to connect HMI， and confirm the status “USB:OK” to be displayed in this software .

8. Select menu “Configuration” -à “option”

9. Input the “download address” like following. The address is “0x31000000”

10. Click “OK” to confirm it.

11. Select menu “USB port”-à “transmit” and select image file “NK.bin”.

12. Then dots will be printed in your hyper terminal， it means the nand flash is been refreshing. It will take about 5 minutes and then boot windows CE.

http://www.wecon-tech.com/n1789944/How+to+download+WINCE+image.htm